Kiln Venting - Electric Kilns

The CRESS Vent System prevents fumes from escaping from the kiln by creating a small negative pressure within the kiln body. The negative pressure is sufficient to prevent the escape of fumes, but does not cause excessive heat loss or cooling. The vent fan assembly attaches to the bottom of the kiln control panel. Fan ready kilns have pre-installed wiring that plugs into the fan assembly when it is attached. At the same time, the fan also draws air from inside the kiln body into the control panel. The air from inside the kiln body passes into the control panel through small holes in the kiln wall. The small amount of hot kiln air mixes with the room temperature within the control panel prior to being exhausted. For this reason the exhaust air remains relatively cool. CSA and UL Std 499 Certified. Ship wt. is 15 lbs.

The EnviroVent 2 is a Downdraft Ventilation System designed to extract fumes from your electric kiln and vent them outdoors before they have a chance to enter the room. Because it is a DownDraft Ventilation System, the EnviroVent 2 also improves the firing atmosphere in the kiln while it is protecting you from the odorous fumes that can be emitted from certain clay bodies and glazes when they are fired. Ship wt. is 17 lbs.

The EnviroLink was developed by engineers at Skutt to provide kiln owners with the ability to automatically control the Skutt EnviroVent and EnviroVent 2. The device utilizes a programmable power output (OUTPUT 4) on Skutt KilnMaster and GlassMaster Controllers to turn on/off the EnviroVent and EnviroVent 2. The kiln may be programmed to control the vent during any segment of a Ramp/Hold Program or during preset times of a ConeFire or Glass Fire Mode program. Ship wt. is 2 lbs.

The Dual Intake Kit allows you to vent 2 kilns up to 12 cubic feet each, or one kiln between 12 and 24 cubic feet, with one EnviroVent 2 Motor.

8' x 3" ducting used to extend original duct.